Volume 47, No.2 May 2004

Series B: Fluids and Thermal Engineering

 

Contents

Special Issue on International Conferences on Power and Energy System

155    Foreword

Mamoru ARAOKA

156    Fluid Flow and Heat Transfer of Natural Convection around Heated Vertical Cylinders
        (Effect of Cylinder Diameter)

Fumiyoshi KIMURA, Tatsuo TACHIBANA, Kenzo KITAMURA and Tsutomu HOSOKAWA

162    Effect of Non-Condensable Gas Mass Fraction on Condensation Heat Transfer for Water-Ethanol Vapor Mixture

Shixue WANG and Yoshio UTAKA

168    Boiling Heat Transfer Characteristics with Highly Wettable Heated Surface under Forced Convection Conditions

Toru MITSUTAKE, Fumihisa KANO, Tetsuo OOSATO, Akio SAYANO, Miyuki AKIBA and Shinichi MOROOKA

173    Structural Optimization of an Energy Supply System from Economic Viewpoint

Satoshi GAMOU, Koichi ITO, Ryohei YOKOYAMA and Shu YOSHIDA

180    Influence of Two-Stage Air Injection Conditions on NO_x and Unburned Carbon of Sub-Bituminous Coal Combustion

Michitaka IKEDA, Hisao MAKINO, Hideki MORINAGA and Koichi HIGASHIYAMA

186    Pressurized Fluidized Bed Combustion of Sewage Sludge
        (Energy Recovering from Sewage Sludge by Power Generation System)

Yoshizo SUZUKI, Tomoyuki NOJIMA, Akihiko KAKUTA and Hiroshi MORITOMI

193    System Outline and Operational Status of Karita Power Station New Unit 1 (PFBC)

Akihisa ASAI, Kazuhiro IZAKI, Youichi EGAMI, Kouhei TSUJI, Shunji KUMAGAI and Yuuji NISHIJIMA

200    An Experimental Investigation and Numerical Analysis of Multi-Component Fuel Spray

Kwang-Jae MYONG, Motoyuki ARAI, Tomoyuki TANAKA, Jiro SENDA and Hajime FUJIMOTO

207    Diffusion Combustion in a Tube-Nested Combustor

Tetsuji SEKO, Ryosuke MATSUMOTO, Yoshitomo SHINTANI, Isao ISHIHARA and Mamoru OZAWA

214    Development of Low-NO_x Emission DME (Dimethyl Ether) Combustor

Ryosuke MATSUMOTO, Isao ISHIHARA, Mamoru OZAWA and Keizo IMAHORI

221    Flame Stability Limit and Exhaust Emissions of Low Calorific Fuel Combustion in Turbulent Diffusion Combustor for a Small-Scale Fuel Cell

Hidenori KOSEKI

228    The Structure of Catalyst Layers and Cell Performance in Proton Exchange Membrane Fuel Cells

Hiroyuki INOUE, Hirofumi DAIGUJI and Eiji HIHARA

235    The Design and Performance of a PEFC at a Temperature Below Freezing

Yukio HISHINUMA, Takemi CHIKAHISA, Fumio KAGAMI and Tomohiro OGAWA

242    Influence of Refrigerant Mass Fraction in the Performance of an Ammonia Absorption Refrigerator

Keisuke TAKESHITA, Yoshiharu AMANO, Takumi HASHIZUME, Toshitaka TAKEI and Masao TOMIZAWA

249    Medium-Pressure Hydrogen-Oxygen Combustion Turbine Systems for Utilization of Industrial Waste Heat

Hirohide FURUTANI and Nikolaj UZUNOW

256    Proposal of the Atmospheric Pressure Turbine (APT) and High Temperature Fuel Cell Hybrid System

Yoshiharu TSUJIKAWA, Ken-ichi KANEKO and Jun SUZUKI

261    Research and Development for Gas Turbine System in GTHTR300

Kazuhiko KUNITOMI, Shoji KATANISHI, Shoji TAKADA, Takakazu TAKIZUKA, Xing YAN and Shinichi KOSUGIYAMA

268    The Role of Fragmentation Mechanism in Large-Scale Vapor Explosions

Jie LIU, Seiichi KOSHIZUKA and Yoshiaki OKA

277    Multi Parameters Effect on Thermohydraulic Instability in Natural Circulation Boiling Water Reactor during Startup

Muhammad Hadid SUBKI, Masanori ARITOMI, Noriyuki WATANABE, Moon Ki CHUNG and Hiroshige KIKURA

287    Reflection and Diffraction Phenomena of Blast Wave Propagation in Nuclear Fuel Cycle Facility

Akihiko MIURA, Akiko MATSUO, Toshiharu MIZUKAKI, Takuya SHIRAISHI, Go UTSUNOMIYA, Kazuyoshi TAKAYAMA and Ichiro NOJIRI

293    Pressure Drop Characteristics in Tight-Lattice Bundles for Reduced-Moderation Water Reactors

Hidesada TAMAI, Masatoshi KURETA, Hiroyuki YOSHIDA and Hajime AKIMOTO

299    Critical Power in 7-Rod Tight Lattice Bundle

Wei LIU, Masatoshi KURETA and Hajime AKIMOTO

306    Critical Heat Fluxes of Subcooled Water Flow Boiling against Inlet Subcooling in Short Vertical Tube

Koichi HATA, Hirokazu KOMORI, Masahiro SHIOTSU and Nobuaki NODA

316    SCC Life Estimation Based on Cracks Initiated from the Corrosion Pits of Bolting Material SCM435 Used in Steam Turbine

Hitomi ITOH, Mayumi OCHI, Isao FUJIWARA and Takashi MOMOO

323    Numerical Analysis of a Water-Vapor Two-Phase Film Flow in a Narrow Coolant Channel with a Three-Dimensional Rectangular Rib

Kazuyuki TAKASE, Hiroyuki YOSHIDA, Yasuo OSE and Hidesada TAMAI

332    Lead-Bismuth Eutectic Compatibility with Materials in the Concept of Spallation Target for ADS

Kenji KIKUCHI, Shigeru SAITO, Yuji KURATA, Masatoshi FUTAKAWA, Toshinobu SASA, Hiroyuki OIGAWA, Eiichi WAKAI, Makoto UMENO, Hiroshi MIZUBAYASHI and Kuniaki MIURA

340    Conceptual Design of Low-Temperature Hydrogen Production and High-Efficiency Nuclear Reactor Technology

Kimichika FUKUSHIMA and Takashi OGAWA

344    Critical Power Performance of Tight Lattice Bundle

Yasushi YAMAMOTO, Kouji HIRAIWA, Shinichi MOROOKA and Nobuaki ABE

351    Study on Ex-Vessel Cooling of Reactor Pressure Vessel
        (Model Analysis of Critical Heat Flux on Inclined Plate and Hemisphere Facing Downward)

Hiroyasu OHTAKE and Yasuo KOIZUMI

358    Research Activities for Nuclear Power Plant Aging Promoted by PLEC, JAPEIC, Japan

Noriyoshi MAEDA and Kenichi TAJIMA

363    Analysis of Noncontact Squeegeeing Device for Liquid Toner Electrophotography

Shuzo HIRAHARA, Norio YOSHIKAWA, Hideki NUKADA, Haruhi OH-OKA and Masahiro HOSOYA

369    Reconstruction of Free Fall Particle CT Images Using the Generalized Vector Sampled Pattern Matching Method

Masahiro TAKEI, Mitsuaki OCHI, Yoshifuru SAITO and Kiyoshi HORII

378    A Gust Model for Wind Turbine Design

Wim BIERBOOMS

387    Development of Decision Model for Selection of Appropriate Power Generation System Using Distance Based Approach Method

Anugerah WIDIYANTO, Seizo KATO and Naoki MARUYAMA

396    A New CFD Model for VOC Emission Based on the General Adsorption Isotherm

Baoqing DENG and Chang Nyung KIM

403    Combustion Simulation Using the Lattice Boltzmann Method

Kazuhiro YAMAMOTO, Xiaoyi HE and Gary D. DOOLEN

410    Effects of Injection Timing on Mixture Distribution in a Liquid-Phase LPG Injection Engine for a Heavy-Duty Vehicle

Yonggyu LEE, Changup KIM, Seungmook OH and Kernyong KANG

---

---

E-mail:journal@jsme.or.jp

All Rights Reserved, Copyright (C) 2004, The Japan Society of Mechanical Engineers.