Volume 47, No.3 July 2004

Series A: Solid Mechanics and Material Engineering

 

Contents

Special Issue of Advanced Technology of Experimental Mechanics

237    Foreword

Keisuke TANAKA

238    Failure by Fracture and Fatigue in "Nano" and "Bio" Materials

R.O.RITCHIE, C.L.MUHLSTEIN and R.K.NALLA

252    Diffraction Measurements of Resideual Macrostress and Microstress Using X-Rays, Synchrotron and Nentrons

Keisuke TANAKA and Yoshiaki AKINIWA

264    Measurement of Crack Opening Displacement and Energy Release Rate of Rapidly Bifurcating Cracks in PMMA by High-Speed Holographic Microscopy

Shinichi SUZUKI and Kenichi SAKAUE

274    Measurement of Deformation of Wood Joints Using Electronic Speckle Pattern Interferometry

Eisaku UMEZAKI, Takao SUZUKI and Masamitsu TAKAHASHI

280    In-Situ Observation of Alumina Particles in Molten Aluminum Using a Focused Ultrasonic Sensor

Ikuo IHARA, Hiroshi ASO and Dikky BURHAN

287    Effective Transmission of High Frequency Ultrasound into a Silicon Chip through a Polymer Layer

Hironori TOHMYOH and Masumi SAKA

294    Quantitative Evaluation of Moisture in Encapsulant Resin of IC Packages by Microwaves

Yang JU, Yasushi OHNO, Masumi SAKA and Hiroyuki ABÉ

298    Experimental Stress Separation Technique Using Thermoelasticity and Photoelasticity and Its Application to Fracture Mechanics

Takahide SAKAGAMI, Shiro KUBO, Yasuyuki FUJINAMI and Yousuke KOJIMA

305    Stress Separation in Thermoelastic Stress Analysis Using Nonlinearity of the Thermoelastic Effect

Hirotsugu INOUE, Yoshihiro HIROKAWA and Kikuo KISHIMOTO

312    Evaluation of Internal Stresses in Single-, Double-and Multi-Layered TiN and TiAlN Thin Films by Synchrotron Radiation

Takao HANABUSA, Kazuya KUSAKA, Tatsuya MATSUE, Masayuki NISHIDA, Osami SAKATA and Toshiki SATO

318    Estimation of Spalling Stress in Thermal Barrier Coatings Using Hard Synchrotron X-Rays

Kenji SUZUKI, Keisuke TANAKA and Yoshiaki AKINIWA

324    Direct Measurement of Interface Strength between Copper Submicron-Dot and Silicon Dioxide Substrate

Hiroyuki HIRAKATA, Takayuki KITAMURA and Yoshitake YAMAMOTO

331    Fatigue Crack Initiation Behavior in Ultrafine-Grained Steel Observed by AFM and EBSP

Hidehiko KIMURA, Yoshiaki AKINIWA, Keisuke TANAKA, Yasuaki TAHARA and Tadashi ISHIKAWA

341    Microscopic Residual Stress Caused by the Mechanical Heterogeneity in the Lamellar Unit of the Porcine Thoracic Aortic Wall

Takeo MATSUMOTO, Taisuke GOTO and Masaaki SATO

349    Thermomechanical Analysis of Micromechanical Formation of Residual Stresses and Initial Matrix Failure in CFRP

Thomas HOBBIEBRUNKEN, Masaki HOJO, Bodo FIEDLER, Mototsugu TANAKA, Shojiro OCHIAI and Karl SCHULTE

357    Electrical Resistance Change of Unidirectional CFRP Due to Applied Load

Akira TODOROKI and Jyunji YOSHIDA

365    The Space Exposure Experiment of PEEK Sheets under Tensile Stress

Takashi NAKAMURA, Hiroshi NAKAMURA, Osamu FUJITA, Toru NOGUCHI and Kichiro IMAGAWA

371    Plasticity-Creep Separation Method for Viscoplastic Deformation of Lead-Free Solders

Ken-ichi OHGUCHI, Katsuhiko SASAKI, Masahiro ISHIBASHI and Takamichi HOSHINO

380    Creep-Fatigue Properties of Sn-37Pb Solder Material Evaluated by Room Temperature Testing under Various Strain Waveforms

Katsuyuki TOKIMASA

389    Fatigue Crack Propagation in Surface Film-Bonded Materials Using Pure Copper and Commercial Grade Iron Films

Tashiyuki TORII and Akira MATSUBA

397    Simulation of Directional Distribution of Slip-Band Crack under Biaxial Low Cycle Fatigue

Toshihiko HOSHIDE and Yuko TAKAHASHI

403    Study on the Fatigue Crack Growth Problem under Mode I+II Mixed Mode Condition with Elastic-Plastic Deformation

Masanori KIKUCHI and Toshiaki SATO

410    Micro-Macro Combined Simulation of the Damage Progress in Low-Alloy Steel Welds Subject to Type IV Creep Failure

Fumiko KAWASHIMA, Toshihide IGARI, Takumi TOKIYOSHI, Akira SHIIBASHI and Naoya TADA

419    An Experimental Study on Applicability of Passive Electric Potential CT Method to Crack Identification

Daiki SHIOZAWA, Shiro KUBO and Takahide SAKAGAMI

426    Fatigue Failure by Flow-Induced Vibration
        (Effect of Initial Defect Size on Cumulative Fatigue Damage)

Satoru ODAHARA, Yukitaka MURAKAMI, Masahiro INOUE and Atsuo SUEOKA

438    Discrete Element Method Simulation of the Restitutive Characteristics of a Steel Spherical Projectile from a Particulate Aggregation

Masahiro NISHIDA, Koichi TANAKA and Yukinori MATSUMOTO

448    Development of an Atomic Force Microscope Ultra-Microhardness Tester with a Silicon Tip for High-Resolution AFM Imaging

Nobuo NAGASHIMA, Kensuke MIYAHARA and Saburo MATSUOKA

457    Investigating the Behavior of a Griffith Crack at the Interface between Isotropic and Orthotropic Elastic Half-Planes for the Opening Crack Mode

Yu-Guo SUN, Zhen-Gong ZHOU and Lin-Zhi WU

467    Investigation of the Behavior of an Interface Crack between Two Half-Planes of Orthotropic Functionally Graded Materials by Using a New Method

Zhen-Gong ZHOU, Biao WANG and Li-Jian YANG

479    Correlation between Cleavage Fracture Toughness and Charpy Impact Properties in the Transition Temperature Range of Reactor Pressure Vessel Steels

Kunio ONIZAWA and Masahide SUZUKI

486    Probabilistic Fracture Mechanics Analyses of Reactor Pressure Vessel under PTS Transients

Kunio ONIZAWA, Katsuyuki SHIBATA, Daisuke KATO and Yinsheng LI

494    Process Development and Material Property of ZnO Nanoparticle Suspension by High Frequency Induction

Ho CHANG, Tsing Tshih TSUNG, Liang Chia CHEN, Yu Cheng CHEN, Hong Ming LIN and Chung Kwei LIN

502    Application of Friction Stir Welding to Construction of Railway Vehicles

Takeshi KAWASAKI, Toshiaki MAKINO, Kentarou MASAI, Hideshi OHBA, Yoshihiko INA and Masakuni EZUMI

512    Effect of Void Shape and Its Growth on Forming Limits for Anisotropic Sheets Containing Non-Spherical Voids

Hyun-Sung SON, Young-Suk KIM, Kyoung-Hoan NA and Sang-Moo HWANG

---

---

E-mail:journal@jsme.or.jp

All Rights Reserved, Copyright (C) 2004, The Japan Society of Mechanical Engineers.