Volume 48, No.4 November 2005

Series B: Fluids and Thermal Engineering

 

Contents

Special Issue on Advanced Combustion Technology in Internal Combustion Engines

631    Foreword

Eiichi MURASE

632    Time-Resolved Laser-Induced Incandescence Measurements for the EPA Heavy-Duty Federal Test Procedure

Peter WITZE, Shirish SHIMPI, Russ DURRETT and Lisa FARRELL

639    Primary and Aggregate Size Distributions of PM in Tail Pipe Emissions form Diesel Engines

Masataka ARAI, Kenji AMAGAI, Takayuki NAKAJI and Shinji HAYASHI

648    Diesel Combustion and Emission Using High Boost and High Injection Pressure in a Single Cylinder Engine
        (Effects of Boost Pressure and Timing Retardation on Thermal Efficiency and Exhaust Emissions)

Yuzo AOYAGI, Eiji KUNISHIMA, Yasuo ASAUMI, Yoshiaki AIHARA, Matsuo ODAKA and Yuichi GOTO

656    A Parametric Study of Low-Temperature, Late-Injection Combustion in a HSDI Diesel Engine

Dae CHOI, Paul C. MILES, Hanho YUN and Rolf D. REITZ

665    NOx Reduction in Diesel Combustion by Enhanced Mixing of Spray Tip Region

Tomomi KANEKO, Takeshi FUJII, Yuji MATSUDA and Takemi CHIKAHISA

671    Comparison of Three Soot Models Applied to Multi-Dimensional Diesel Combustion Simulations

Feng TAO, Sukhin SRINIVAS, Rolf D. REITZ and David E. FOSTER

679    Quantitative Analysis of Mixture Preparation Processes in New Direct-Injection Spark Ignition Engines

Teruyuki ITOH, Akihiko KAKUHO, Koji HIRAYA, Eiji TAKAHASHI and Tomonori URUSHIHARA

687    Enhancement of Stratified Charge for DISI Engines through Split Injection
        (Effect and Its Mechanism)

Tie LI, Keiya NISHIDA, Yuyin ZHANG, Tuyoshi ONOE and Hiroyuki HIROYAU

695    Analysis of Knock Phenomenon Induced in a Constant Volume Chamber by Local Gas Temperature Measurement and Visualization

Yasuo MORIYOSHI, Shigemi KOBAYASHI and Yoshiteru ENOMOTO

701    Studies of the Combustion Process with Simultaneous Formaldehyde and OH PLIF in a Direct-Injected HCCI Engine

Mattias RICHTER, Robert COLLIN, Jenny NYGREN, Marcus ALDEN, Leif HILDINGSSON and Bengt JOHANSSON

708    Impact of Formaldehyde Addition on Auto-Ignition in Internal-Combustion Engines

Kazunari KUWAHARA, Hiromitsu ANDO, Masahiro FURUTANI and Yasuhiko OHTA

717    Application of a Genetic Algorithm to the Optimization of Rate Constants in Chemical Kinetic Models for Combustion Simulation of HCCI Engines

Sang-kyu KIM, Kazuma ITO, Daisuke YOSHIHARA and Tomoyuki WAKISAKA

725    Research on the Influence of Hydrogen and Carbon Monoxide on Methane HCCI Combustion

Susumu SATO, Yudai YAMASAKI, Hideo KAWAMURA and Norimasa IIDA

735    Study on Interfacial Phenomena of Magnetic Fluids

Yoshiyuki FUKUDA and Noriyoshi DOUHARA

743    Study on Differences in Turbulence Statistics between Compressible and Incompressible Low-Reynolds Number Turbulent Channel Flows Using Semi-Local Scaling

Youhei MORINISHI and Shinji TAMANO

750    Ni Nano-Magnetic Fluid Prepared by Submerged Arc Nano Synthesis System (SANSS)

Chih-Hung LO, Tsing-Tshih TSUNG and Liang-Chia CHEN

756    Tip Velocity of Viscous Fingers in Shear-Thinning Fluids in a Hele-Shaw Cell

Takehiro YAMAMOTO, Ryusuke KIMOTO and Noriyasu MORI

763    Performance and Internal Flow of Cross-Flow Fan with Inlet Guide Vane

Junichiro FUKUTOMI and Rei NAKAMURA

770    Micro-Electrohydrodynamic Pump by Dielectric Fluid

Ichiro KANO and Yoshio KANO

776    Scattering of Plane Waves by a Rigid Sphere in an Acoustic Quarterspace

Seyyed Mohammad HASHEMINEJAD and Seyyed Ali BADSAR

783    Helical Instability Wave Excitation in Swirling Jets by a Novel Mechanical Device

Wonjoong LEE and Ray TAGHAVI

793    Optimization of Blade Sweep in a Transonic Axial Compressor Rotor

Choon-Man JANG, Ping LI and Kwang-Yong KIM

802    Monte Carlo Approach to Structure and Thermodynamic Property of CO₂ Hydrate

Masahiro OTA and Mohammad FERDOWS

810    Heat Transfer Characteristics and Performance of a Spirally Coiled Heat Exchanger under Sensible Cooling Conditions

Somchai WONGWISES and Paisarn NAPHON

820    A Three-Dimensional Numerical Investigation into the Interaction of Blast Waves with Bomb Shelters

Chang-Hsien TAI, Jyh-Tong TENG, Shi-Wei LO and Chia-Wei LIU

830    Flow Field in Swirl-Type Tubular Flame Burner

Yuyin ZHANG, Daisuke SHIMOKURI, Yoshihisa MUKAE and Satoru ISHIZUKA

839    A Study of the Effect of Oxygen Concentration on the Soot Deposition Process in a Diffusion Flame along a Solid Wall by In-Situ Observations in Microgravity

Jae-Hyuk CHOI, Osamu FUJITA, Takafumi TSUIKI, Junhong KIM and Suk-Ho CHUNG

849    Numerical Investigation of Edge Flame Structure of Counterflow Nonpremixed Flames with Local Extinction Due to Flame Stretch

Susumu NODA and Tomonori TSUBOKURA

858    Atomization Performance of an Atomizer with Internal Impingement

Muh-Rong WANG, Tien-Chu LIN, Teng-San LAI and Ing-Ren TSENG

865    Thermal Response of Electronic Assemblies during Forced Convection-Infrared Reflow Soldering in an Oven with Air Injection

Young-Seok SON and Jee-Young SHIN

874    Conversion Characteristics of Double-Layer Washcoat Tri-Metal Three-Way Catalyst Using High Cell Density Substrate

Byungchul CHOI, Jongwoo JEONG, Geonseog SON and Myunggun J UNG

---

---

E-mail:journal@jsme.or.jp

All Rights Reserved, Copyright (C) 2005, The Japan Society of Mechanical Engineers.