［Stress and Deformation Analysis］

● Yield Stress of Randomly Perforated Sheets and Anisotropic Yield Function（96-0077）

Yasuhide NAKAYAMA, Shigeru NAGAKI and Takeji ABE

● Axisymmetric Stress Analysis and Strength of Bonded Shrink-Fitted Joints Subjected to Push-Off Forces（96-0391）

Masahiro YONENO, Toshiyuki SAWA, Ken SHIMOTAKAHARA and Yoichi MOTEGI

● Application of Element-Free Trefftz Method to Second-Order Design Sensitivity Analysis of Two-Dimensional Elastic Problem（96-0387）

Eisuke KITA, Yoji KATAOKA and Norio KAMIYA

 

● Treatment of Boundary Conditions in One-Dimensional Wavelet-Galerkin Method（97-4012）

Dianfeng LU, Tadashi OHYOSHI and Kimihisa MIURA

● Thermoelastic Design of Symmetric Laminates Using Lamination Parameters（97-4028） 　

Hisao FUKUNAGA, Takashi ISHIKAWA, Masaki SATO and Hideki SEKINE

● A Strip Element Method for Bending Analysis of Orthotropic Plates（97-4031）

Yu Yong WANG, Khin Yong LAM, Gui Rong LIU, J.N. REDDY and Junji TANI

● Stress Measurement Using the Caustics Method under Distributed Load Conditions（96-5027）

Jianding WANG and Kiyoshi ISOGIMI

● Thermal Shock Parameters of Ceramics Evaluated by Infrared Radiation Heating（97-4001）

Hideo AWAJI, Sawao HONDA and Tadahiro NISHIKAWA

● Mesoscopic Fracture Mechanism of Mode II Delamination Fatigue Crack Propagation in Interlayer-Toughened CFRP（96-0059）

Satoshi MATSUDA, Masaki HOJO and Shojiro OCHIAI

● Atomic Simulation on Deformation and Fracture of Nano-Single Crystal of Nickel in Tension（95-1908）

Takayuki KITAMURA, Kisaragi YASHIRO and Ryuichi OHTANI

● Corrosion Resistance and Corrosion Fatigue Strength of Carbon Steel Coated with Chromium Nitride by Multistage PVD Method（95-2008）

Masaru SONOBE, Kazuaki SHIOZAWA and Kou MOTOBAYASHI

● Fatigue Strength Evaluation of Cracked Components（96-0818）

Luoming ZHANG, Yoshiaki AKINIWA and Keisuke TANAKA

● Direct Bonding between Aluminum and Silicon by the Formation of Hydrogen Bonds（96-4070）

Masao NAGAKUBO, Harumi SUZUKI and Tadashi HATTORI

● Application of an Elastic Roller with Slightly Convex Shape in the Improvement of the Flatness of a Strip for Cold Rolling（96-5018）

Zone-Ching LIN and Shyue-Yuan LEE